PACSystems™ RX7i CPU IC698CRE020 CPU Module 700 MHz
Series 90-70 Module Compatibility The following Series 90-70 modules are supported by the PACSystems RX7i: Discrete Input Modules (IC697MDL240/241/250-254/640/651-654/671) Discrete Output Modules (IC697MDL340/341/350/740/750/752/753/940) Analog I/O Modules (IC697ALG230/320/440/441) Genius Bus Controller (IC697BEM731) High Speed Counter (IC697HSC700) Bus Transmitter Module (IC697BEM713/731) Bus Receiver Module (IC697BEM711) in Series 90-70 Expansion Rack only. Programmable Coprocessor Module (IC697PCM711). For details, see the “CPU Operational Notes“ section on page 15. Communications Coprocessor Module (IC697CMM711) For details, see the “CPU Operational Notes“ section on . DLAN Module (IC697BEM763 For details, see the “CPU Operational Notes“
Any BTM (IC697BEM713) used must be at least version H, hardware rev R08 or greater. Any BRM (IC697BEM711) used must be at least version M, hardware rev R13 or greater
Any Genius Bus Controller (IC697BEM731) used must be revision 5.8 or greater, hardware revision G or greater. To obtain this revision of the GBC, you must order upgrade kit 44A751619-G01.
Analog module requirements are as follows:
IC697ALG230 used must be version F or greater.
IC697ALG320 used must be version D or greater.
IC697ALG440 used must be version D or greater.
IC697ALG441 used must be version C or greater.
■ Hot Standby CPU Redundancy (including new CPU module CRE020). Hot Standby CPU Redundancy is a system in which two PLC CPU units are cooperating to control the same process. There is an Active Unit that is actively controlling the process and a Backup Unit that is synchronized with the Active Unit and able to take over the process should it become necessary. The two units are synchronized when both are in Run Mode and the Backup Unit has received the latest status and synchronization information from the Active Unit and both are running their logic solution in parallel. The Backup unit is a Hot Standby unit, capable of taking over the process. Redundant I/O capability is based on the Genius I/O System.
All new products and surplus products of the industrial intelligence industry, as well as the discontinued products of the original manufacturers. We are not an authorized distributor or representative of any of the above manufacturers (except for brand authorization). The trademarks, brand names and brands appearing in this agreement are the property of their respective manufacturers.
COPYRIGHT© 2003-2024 Copyrighted
Phone(WeChat/Whatsapp)
+086-18144100983
No 1134 Jimei North Road, Jimei District
Hong Kong Office:
Guan Tang District, Hong Kong,