reliance Distributed Power System SA3100 Drive Configuration and Programming

SA3100 drives operate under the control of the AutoMax™ Distributed Power System

(DPS). DPS drives are controlled through coordination among:

• Tasks written by the programmer for the AutoMax Processor.

• Tasks written by the programmer for the Universal Drive Controller (UDC) module.

• The control algorithm and a number of software routines executed by the Power

Module Interface (PMI) regulator.

The data and commands required by the PMI operating system to carry out its

functions are provided by the programmer through the AutoMax rack configuration

and the UDC task. The programmer provides this information by:

• Entering the drive parameters.

• Configuring the registers in the UDC module.

• Defining the values of the pre-defined local tunables.

• Writing the UDC task.

This manual describes the configuration and programming necessary to control

SA3100 drives. Refer to the publications listed in table 1.1 for detailed descriptions of

the components of an SA3100 drive system.

The AutoMax Programming Executive Version 3.5A (M/N 57C657) or later is required

to support the SA3100 Drive. Drive regulators are sold separately. The AutoMax

Programming Executive instruction manual describes the AutoMax DPS Software

Executive in detail.

This instruction manual assumes that you are familiar with the AutoMax Programming

Executive software and makes reference to it throughout. This manual does not

describe specific applications of the standard hardware and software.