ABB AO2000-LS25 Laser analyzers

pause after dialing the zero before dialing the rest of the digits. If additional pausing is

needed, apply "," between the digits.

If communication via LAN is used, you will be asked for IP address and port number: The IP

address and port number are typically set to default values 192.168.1.237 and 5001, respectively.

If the IP address and port number need to be changed, run the program with direct serial

connection and configure TCP/IP parameters as described in Section 4.3.8.

After the connection with the instrument has been established you are prompted to start the

program in User or Advanced mode.

Press <User mode> to start the program. This program mode provides a simplified interface

with limited access to the instrument setting parameters and should be used during installation

and normal operation of the instrument. A password is only required for Advanced mode

that enables full access to all the instrument setting parameters. This program mode should

be used during service adjustment of the instrument. Your local distributor or ABB can provide

the password on request.