PanelView 550 Terminals     5Publication 2711-IN009E-EN-P - February 2009Wiring and Safety GuidelinesInstall the PanelView 550 terminal using publication 70E, Electrical Safety Requirements for Employee Workplaces. In addition to the NFPA general guidelines, follow these recommendations:

•Connect the PanelView terminal to its own branch circuit.

•The input power source should be protected by a fuse or circuit breaker rated at no more than 15 amps.

•Route incoming power to the PanelView 550 terminal by a separate path from the communications cable.

•Where power and communication lines must cross, they should cross at right angles. Communications lines can be installed in the same conduit as low level DC I/O lines (less than 10 Volts).

•Grounding minimizes noise from Electromagnetic Interference (EMI) and is a safety measure in electrical installations. To avoid EMI, shield and ground cables appropriately.

•A source for grounding recommendations is the National Electrical Code published by the National Fire Protection Association of Boston

2711-K3A5L1

2711-K3A10L1

2711-K3A17L1

2711-M3A19L1

2711-M3A18L1

2711-B6C1

2711-B6C2

2711-B6C3

2711-B6C5

2711-B6C8

2711-B6C9

2711-B6C10

2711-B6C15

2711-B6C16

2711-B6C20

2711-K6C1

2711-K6C2

2711-K6C3

2711-K6C5

2711-K6C8

2711-K6C9

2711-K6C10

2711-K6C15

2711-K6C16

2711-K6C20

2711-T6C1L1

2711-T6C2L1

2711-T6C3L1

2711-T6C5L1