SST-PFB-CLX Remote Rack Configuration.PDF  

This document applies to the SST-PFB-CLX module.

Copyright ©2003 Woodhead Software and Electronics, a division of Woodhead Canada Limited.

This document contains information proprietary to Woodhead Software and Electronics. Any disclosure, use or duplication of this document or any of the information contained herein, for other than the specific purpose for which it was disclosed is expressly prohibited, except as Woodhead Software and Electronics, A Division of Woodhead Canada Limited may otherwise agree to in writing.

SST is a trademark of Woodhead Software & Electronics. All other trade names are trademarks or registered trademarks of their respective companies.

We at Woodhead strive to ensure accuracy in our documentation. However, due to rapidly evolving products, on occasion software or hardware changes may not have been reflected in the documentation. If you notice any inaccuracies, please contact us (contact information at end of document).

To design a redundant Profibus I/O control system with ControlLogix architecture, the SST-PFB-CLX card must be installed in a remote ControlLogix rack. In this setup, it communicates with ControlLogix CPUs via the 1756-CNB family of ControlNet bridge cards.

Although SST’s documentation explains how to set up the SST-PFB-CLX card and ControlLogix CPU to communicate through the local rack, no SST documentation describes how to use the card remotely (as required for a redundant system).

According to document 1756Soft_HBU.pdf, Application Solution “Software Output System” (Publication number 1756-AP001A-US-E), it is possible to build a ControlLogix redundant system without the 1757-SRM modules, using ladder logic to switch control between CPUs.