ABB 3HAC17346-1/01

ABB 3HAC17346-1/01

3BUR001978R3701

AdvaBuild 3.7 ControlBuilder User'sGuide

3BUR001980R3701

AdvaBuild 2.7-3.7 TCL User's Guide

3BUR001981R3701

AdvaBuild 2.7-3.7 TLL User's Guide

3BUR002065R3701

AdvaBuild 3.7 Migration User's Guide

3BUR002095R1

DSAI 133K02 Red AI Kit, 32ch, 12bit sing

3BUR002099R1

DSAX 110AK02 AI/AO Kit, 8+8ch, 12bit

3BUR002102R1

Power Supply Tray Kit for RE2x0 cabinets

3BUR002117R3701

AdvaBuild 3.7 TCL Builder User's Guide

3BUR002121R3701

AdvaBuild 3.7 TLL Builder User's Guide

3BUR002124R1

DSDX 180AK01 DI/DO Kit, 32ch

3BUR002125R1

DSDX 180AK02 Red DI/DO Kit, 32ch

3BUR002242R1

CS513K06 Redundant DCN to eDCN AC400

Normally, the operating range is determined automatically during Autoadjust. A partial run of Autoadjust that is limited to the control parameters (STANDARD, see parameter ADJ_MODE) or valves and fittings without end stops, however, requires manual adjustment of the operating range.

The range between high and low limit value must be at least 10% of the full range. Otherwise, the message VR<10% is displayed. 

Important 

Use as large are range as possible. This parameter is not active when the safe position is active. The display then shows the message FAIL_POS. 

You use MAX_VR to determine the upper limit of the operating range.

up or down     Press in order to travel to the desired position. 

ENTER     Press and hold until the countdown is finished (MIN_SET). The position is taken over as min. limit value. 

ENTER     Press briefly. The set limit value is displayed for 2 seconds (MIN_SAVE).