ABB 3BHB018162R0001
Y3BSE018059R1
RS485 TWISTED PAIR MODEM
Y3BSE018283R1
CI522A, AF100 INTERFACE
Y3BSE018290R1
ANALOG INPUT MODULE SET
Y3BSE018291R1
DSAX 110A REPAIR ITEM
Y3BSE018292R1
DSAI ANALOG INPUT BOARD
Y3BSE018293R1
ANALOG OUTPUT BOARD
Y3BSE018295R1
DSDI 110AV1 REPAIR UNIT
Y3BSE018405R1
AF100 Twisted pair Coax Modem
Y3BSE020520R1
CI810B, REPAIR & RETURN
Y3BSE022178R1
Optical Modem
Y3BSE025255R1
CI820V1, REPAIR & RETURN
Y3BSE032400R1
RTAB BOARD
The test is used to activate the positioner, and you can check the effects of the changes to this parameter group, e.g., by introducing setpoint changes or setpoint ramps using a current source.
Normally, INACTIVE is shown in the display. To start the test, press and hold ENTER until the countdown from 3 to 0 is finished. The test is activated. The display shows the control loop symbol and a flashing message. The test is automatically stopped after two minutes and can also be stopped by pressing any button.
Important
It is not possible to start the test when the safe position is active (see the FAIL_POS parameter). Instead, the message FAIL_POS is displayed.
All new products and surplus products of the industrial intelligence industry, as well as the discontinued products of the original manufacturers. We are not an authorized distributor or representative of any of the above manufacturers (except for brand authorization). The trademarks, brand names and brands appearing in this agreement are the property of their respective manufacturers.
COPYRIGHT© 2003-2024 Copyrighted
Phone(WeChat/Whatsapp)
+086-18144100983
No 1134 Jimei North Road, Jimei District
Hong Kong Office:
Guan Tang District, Hong Kong,