ABB 3ASC25H203
The following values are determined during Autoadjust:
• Direction of the actuator
• Direction of reset spring
• Stroking distance of the actuator
• Stroke time for both directions
• Control parameters
• Offset for the I/P module
Important
The mode and scope of the Autoadjust function can be selected using parameter ADJ_MODE.
To start the Autoadjust, press and hold ENTER until the countdown from 3 to 0 is finished. During the countdown, the Autoadjust mode selected using parameter ADJ_MODE is shown on the display. While Autoadjust is running, the control loop symbol flashes in the display, and the current state of Autoadjust is indicated with the messages listed below.
PM564-R
PM564-R-AC
PM564-R-ETH-AC
PM556-TP-ETH
PM554-TP
PM554-RP
PM554-RP-AC
PM564-TP
PM564-RP
PM564-RP-AC
PM554-TP-ETH
PM564-TP-ETH
PM564-RP-ETH
PM564-RP-ETH-AC
DI561
DI562
DI571
DO561
DO571
DO572
DO562
DO573
DX561
DX571
DC561
DC562
All new products and surplus products of the industrial intelligence industry, as well as the discontinued products of the original manufacturers. We are not an authorized distributor or representative of any of the above manufacturers (except for brand authorization). The trademarks, brand names and brands appearing in this agreement are the property of their respective manufacturers.
COPYRIGHT© 2003-2024 Copyrighted
Phone(WeChat/Whatsapp)
+086-18144100983
No 1134 Jimei North Road, Jimei District
Hong Kong Office:
Guan Tang District, Hong Kong,