ABB 200900-004

ABB 200900-004

Important 

The parameters are only saved in the non-volatile memory by leaving the configuration level via EXIT -> SAVE. 

Multiple parameters in different groups can also be changed sequentially. When leaving the last parameter group via EXIT -> SAVE, all previously made modifications are saved and applied. 

2. Press and hold ENTER until the displayed countdown from 3 to 0 is complete. 

3. Release the ENTER button. The positioner returns to the operating level. The configuration level was accessed from this mode. Depending on the selection the data is saved in the non-volatile memory or discarded. During the save operation a plausibility check is performed. If an error occurs during the check or while data is being saved, an error message is displayed (see the chapter titled "Error messages")

2711-K3A2L1

2711-K3A5L1

2711-K3A10L1

2711-K3A17L1

2711-M3A19L1

2711-M3A18L1

2711-B6C1

2711-B6C2

2711-B6C3

2711-B6C5

2711-B6C8

2711-B6C9

2711-B6C10

2711-B6C15

2711-B6C16

2711-B6C20

2711-K6C1

2711-K6C2

2711-K6C3

2711-K6C5

2711-K6C8

2711-K6C9

2711-K6C10

2711-K6C15

2711-K6C16

2711-K6C20

2711-T6C1L1

2711-T6C2L1

2711-T6C3L1

2711-T6C5L1

2711-T6C8L1

2711-T6C9L1

2711-T6C10L1

2711-T6C15L1

2711-T6C16L1

2711-T6C20L1