CONTROL CARDS The new generation System 57 control cards provide display and alarm facilities for the full range of Sieger gas detectors. 

Their concise, backlit, multi-part LCD displays the gas reading and status in both analogue bargraph and digital numeric forms. In addition, there is an alpha-numeric message section to give sensor (and engineering function) status. General

● 3 levels of alarm 

● Individual, zoned, voted, master, time delayed, update and rate of rise alarm facilities 

● Clear 4 part display 

● Peak reading capability 

● Sensor performance monitoring

5701 CONTROL CARD 

This provides a single channel control function within a 1“ wide package. 

● Independant single channel operation 

● Plug-in input and output options

5704 CONTROL CARD 

This provides four channels of control function within a 1“ wide package. 

● 4-Channel operation ● Choice of output options ● Channel displayed: automatic sequencing, highest reading or combination or manual channel display selection options

ENGINEERING CARD 

The System 57 engineering card provides full maintenance and set up facilities for each channel card. 

The front panel has a series of tactile feedback pushbuttons that allow checks of the alarm levels and performance to be carried out for each channel. A real time ‘on board’ clock provides calibration history and calibration overdue reminder functions. ● Security protected 

● User friendly operation 

● Calibration facility 

● Command accept/abort facility 

● Channel card setup capability

SERIAL COMMUNICATIONS MODULE 

The serial communications module provides a gateway between the System 57 rack and a remote device (DCS, PLC or SCADA package) to allow the continuous monitoring of each channel’s operation and condition as well as allowing remote configuration of the system operation. 

● Industry standard MODBUS protocol 

● RS485/422/232 standard 

● Bi-directional 

● Isolated communications drivers 

● SCADA graphics package available