ANC-100e Ethernet to Data Highway Plus Adapter转换器

• “LED Solid Red” indicates that the device is not currently associated on a DH+ network.

• “LED Solid Green” indicates that the device is associated on the DH+ network

LED labeled “DH+” indicates the current status of the DH+ network:

• “LED Off” indicates that there is no application level traffic coming into or out of the device.

• “LED blinks without any particular pattern of Green and Yellow” indicates that the device is associated with the DH+ network and there is ongoing communication taking place with other nodes on the network. Packet transmission causes Yellow LED to blink, packet reception is indicated by a Green blink.

Accessing ANC-100e User Interface

IMPORTANT: Before proceeding, check that your PC’s Network adapter is configured to match ANC- 100e IP settings. Also make sure the unit is connected to your computer or Ethernet network.

In case the previously configured IP settings were forgotten or lost and connection to the device cannot be established anymore, please perform the factory reset described in chapter “Reset to Default Factory Settings” of this manual.

1. Open any web browser and enter the ANC-120e IP address in the address bar. Default IP address of the device is set to “192.168.0.230”

2. Press “Enter” key

3. Enter the username and password in the corresponding fields. By default, the username is set to “admin” and password to “password”

4. Click “OK” button.

5. If you entered the correct login credentials, you will be presented with the main configuration window.