- 1 x 19“ frame MMS 6352
- 6 x screw terminal MMS 6361
- 6 x cable 0.5 m MMS 6362
alternatively
cable 3 m MMS 6360
- 1 configuration kit MMS 6950
3 x blind plates BLE 008, for
the installation of monitors without
display
When using this system line,
there are additional combinations
available via relay outputs beside
the normal outputs of the alarms
OUT1....OUT6 and the system
supervision Channel Clear:
2 v 3 combination output OUT2
2 v 3 combination output OUT4
OUT5 (= TRIP+CC) channel A
OUT5 (= TRIP+CC) channel B
OUT5 (= TRIP+CC) channel C
System DOPS TS
This system line is used to replace
AEG-Turloop systems.
For the redesign on this system, the
speed monitors MMG 1222 TS are
removed from the slots and
replaced by MMS 6350+MMS 6353
each.
The old, existent Turloop frame
remains in the rack, it is not
necessary to change the wiring.
The following components are
required:
- 3 x monitor MMS 6350 (incl.
firmware appl. no. 1)
In addition:
3 x adapter MMS 6353 TS
- 1 configuration kit MMS 6950
- 1 set of blind plates MMS 6354
The DOPS TS system replaces
the functions of the old Turloop
system. With this system line not
all functions of DOPS or DOPS
AS are at disposal.
The DOPS TS system is not
certified according to SIL3, DIN
EN 61508.
The Profibus-interface is not
available for system line DOPS
TS.
Module supervision
Sensor supervision
All three DOPS system lines offer the
same extensive system supervision
functions.
Reasons for module disturbances
can be read out in detail via the
communication interface or, at
modules with a display, directly on
the display.
This permits the technicians to
recognize the reason for the fault
immediately.
During the change from the error to
the ok-state and after power-on of the
module, all functions of the module
are blocked for a delay time of 5 sec.
Depending on the backplane used
or the installed firmware, the
indication of faults or overspeeds is
made via function-outputs and beside
this via relay outputs with 2 out of 3
combinations of the alarm outputs.
The systems DOPS and DOPS AS
offer the following supervision
functions:
Pulse comparison
Analog comparison
All new products and surplus products of the industrial intelligence industry, as well as the discontinued products of the original manufacturers. We are not an authorized distributor or representative of any of the above manufacturers (except for brand authorization). The trademarks, brand names and brands appearing in this agreement are the property of their respective manufacturers.
COPYRIGHT© 2003-2024 Copyrighted
Phone(WeChat/Whatsapp)
+086-18144100983
No 1134 Jimei North Road, Jimei District
Hong Kong Office:
Guan Tang District, Hong Kong,