EPRO MMS3210/022-000 shaft vibration transmitter

Two independent eddy current sensor inputs. The sensor is Epro PR6422/... , PR6423 /... , PR6424 /... , PR6425 /... And PR6426 /... .

Standard measurement range: selected by toggle switch

Sensor type range

PR6422 /... 1mm

PR6423 /... 2mm

PR6424 /... 4mm

PR6425 /... 4mm

PR6426 /... 8mm/12mm/16mm/20mm

Frequency range: 0... 10 hz;

Linear error: < 0.25%;

Signal output:

Two way 0/4... 20mA current output, one way for each channel, proportional to the corresponding input; Or one current output, proportional to the maximum value of the two-channel measurement.

Allowable load: < 500Ω;

With short circuit and open circuit protection, the cable is connected by clamping terminals.

Temperature drift: zero: < 0.05%/K; Gain range: < 0.01%/K.

Time drift: zero: < 0.05%/24 hours; Gain range: < 0.01%/24 h.

Two buffered voltage outputs (2-10V), one way for each channel, proportional to the input signal, for testing purposes, but also for analytical and diagnostic purposes;

One "OK" state output and two limit output.

Power supply: 18... 24... 31.2 V dc. The transmitter circuit is electrically isolated from the power supply through a DC/DC converter.

Current consumption: about 100mA/24V;

Power consumption: about 2.5 watts.

Environmental conditions :(according to IEC359, DIN43745)

Enclosure: Corrosion resistant, aluminum;

Protection grade: IP65 refer to DIN40050, IEC144 CE certification;

Anti-electromagnetic interference: Refer to EN55011 and EN50082-2;

Operating temperature range: -20... + 80 ℃.

Storage temperature range: -30... + 90 ℃.

Permissible relative humidity: 0... 95% without condensation;

Allows vibration and impact: impact: 20g/2ms; Vibration: 5G at 60Hz.

Installation direction: refer to figure 1 for cable outlet position.

Dimensions: 127.5mm×125.75mm×80mm(width × height × thickness).

Net weight: approx. 1300 grams.

Gross weight: about 1500 grams.

Accessories: Operation manual is provided with the transmitter.

Module/sensor monitoring:

The internal module monitoring circuit can continuously monitor the following conditions:

The sensor signal is within the preset range;