AN-X2-AB-DHRIO PROSOFT EtherNet/IP to DH+ Gateway网关转换器
The AN-X2-AB-DHRIO Gateway is designed to help customers initiate a phased migration approach to replacing or upgrading legacy Remote I/O PLCs, HMI's, Drives or Flex I/O Adapters. These solutions can be achieved by selecting the corresponding operation mode during initial configuration. The AN-X2-AB-DHRIO has a built-in web server that can display diagnostics data, configuration, upload configuration files, and set the operation mode.
This mode supports upgrading legacy Allen Bradley drives on Remote I/O to new EtherNet/IP enabled drives.
No changes to PLC code required Supports up to 4 EtherNet/IP drives
Configurable with 1/4, 1/2 and full rack addressing
Supports all PowerFlex drives on EtherNet/IP
This mode allows legacy PanelViews on Remote I/O or DH+ to be upgraded to a PanelView Plus, PanelView Plus 6 or PanelView Plus 7 on EtherNet/IP.
No changes to PLC code required
Supports up to 8 PanelViews on the same network
Support for DH+ to EtherNet/IP PanelViews upgrades on PLC5 or SLC networks
This mode allows users to replace their existing Remote I/O PLC with a ControlLogix or CompactLogix PAC without having to replace existing racks of I/O.
Build new controller program without interrupting existing controls, minimizing downtime
Supports up to 32 racks of Remote I/O
Supports all Remote I/O baud rates (57.6, 115.2, and 230.4 K baud), and Remote I/O addressing 0 to 76 octal
Works with both ControlLogix or CompactLogix
Auto-Configuration utility discovers baud rate and maps discrete I/O reducing configuration errors
This mode acts as a bridge between an EtherNet/IP and a Data Highway Plus network.
Programming terminals, and/or processors on an EtherNet/IP network can access legacy processors on a DH+ network
Download to a PLC5 or SLC through RSLinx
Configures through web browser
Supports all DH+ baud rates (57.6, 115.2, and 230.4 K baud)
Communication must be initiated from the EtherNet/IP side, DH+ Messages cannot be sent to EtherNet/IP devices
